Table of Contents
Advertisement
5. Serial ATA Connector: SATA1, SATA2
The serial ATA connector is used to connect the
Serial ATA device to the motherboard. These
connectors support the thin Serial ATA cable for
primary internal storage devices. The current
Serial ATA interface allows up to 150MB/s data
transfer rate.
6. CD_IN Connector: CD_IN
CD_IN is Sony standard CD audio connector, it
can be connected to a CD-ROM drive through a
CD audio cable.
7. Front Audio Connector: F_AUDIO
The audio interface provides two kinds of audio
output choices: the Front Audio, the Rear Audio.
Their priority is sequenced from high to low (Front
Audio to Rear Audio). If headphones are plugged
into the front panel of the chassis (using the
Front Audio), then the Line-out (Rear Audio) on
the rear panel will not work. If you do not want to
use the Front Audio, pin 5 and 6, pin 9 and 10
must be SHORT, and then the signal will be
sent to the rear audio port.
1
S A T A 1 / S A T A 2
MIC_IN
MIC_PWR
AUD_OUT_R
NC
AUD_OUT_L
5
GND
TX+
TX-
GND
RX-
RX+
GND
CD_R
GND
1
CD_L
CD_IN
1
2
MIC_GND
+5VA
AUD_RET_R
Empty
AUD_RET_L
9
10
F_ AUDIO
Advertisement
Table of Contents
