Chevrolet Malibu 2015 Owner's Manual page 39

2-10 Keys, Doors, and Windows
2. Immediately after completing
Step 1, press and hold
least four seconds or until the
turn signal lamps flash. The turn
signal lamps flashing confirms
the request to remote start the
vehicle has been received.
When the engine starts, the parking
lamps will turn on and remain on as
long as the engine is running. The
doors will be locked and the climate
control system may come on.
The engine will continue to run for
10 minutes. Repeat the steps for a
10-minute time extension. Remote
start can be extended only once.
Start the vehicle before driving.
Extending Engine Run Time
The engine run time can be
extended by another 10 minutes,
if during the first 10 minutes
Steps 1 2 are repeated while the
engine is still running. When the
remote start is extended, the
second 10 minute period is added
on to the first 10 minutes for a total
for at
of 20 minutes.
The remote start can only be
extended once.
A maximum of two remote starts,
or a single start with an extension,
is allowed between ignition cycles.
The vehicle's ignition must be
turned on and then back off before
the remote start procedure can be
used again.
Canceling a Remote Start
To cancel a remote start, do one of
the following:
Aim the RKE transmitter at the
vehicle and press and hold
until the parking lamps turn off.
Turn on the hazard warning
flashers.
Turn the vehicle on and then off.
Conditions in Which Remote Start
Will Not Work
The remote vehicle start feature will
not operate if:
The key is in the ignition (Key
Access) or if the key is in the
vehicle (Keyless Access).
The hood is not closed.
The hazard warning flashers
are on.
The malfunction indicator lamp
is on.
The engine coolant temperature
is too high.
The oil pressure is low.
Two remote vehicle starts, or a
single remote start with an
extension, have already
been used.
The vehicle is not in P (Park).