Chevrolet Malibu 2015 Owner's Manual page 278

Passenger Side Shown, Driver
Side Similar
1. High-Beam Headlamp
2. Turn Signal Lamps
3. Low-Beam Headlamp
4. Parking Lamp
5. Sidemarker Lamp
To replace one of these bulbs:
High-Beam Headlamp
1. Open the hood. See Hood on
page 10-4.
2. For the driver side bulb, remove
the windshield washer bottle
filler neck by firmly pulling it
straight up and out of the bottle.
3. Remove the cap from the back
of the headlamp assembly by
turning it counterclockwise.
4. Disconnect the electrical
connector (1).
5. Disengage the spring clip (2)
from the bulb by pressing down
on the end and then swing
upward.
6. Remove the bulb from the lamp
assembly.
7. Install a new bulb in the lamp
assembly.
8. Install the spring clip (2).
9. Connect the electrical
connector (1).
Vehicle Care
10. Replace the cap from the back
of the headlamp assembly by
turning it clockwise.
11. For the driver side, reinstall the
windshield washer bottle filler
neck by firmly pushing it
straight into the bottle. Ensure
that the filler neck clip engages
into the underhood electrical
center retainer.
Low-Beam Headlamp
1. For the driver side bulb, remove
the windshield washer bottle
filler neck by firmly pulling it
straight up and out of the bottle.
2. Remove the cap from the back
of the headlamp assembly by
turning it counterclockwise.
3. Disconnect the electrical
connector.
4. Remove the bulb from the lamp
assembly by turning
counterclockwise.
5. Install a new bulb in the lamp
assembly.
10-27