Epson Stylus Pro 7710 Service Manual page 317

Epson Stylus Pro 7700/7710/7900/7910/9700/9710/9900/9910
ADJUSTMENT PROCEDURE (ENTIRE PROCESS WORKFLOW)
1. Turn the printer power on.
2. Start the Service Program, and select [Colorimetric Calibration Tool].
3. Click [Run] to start the "Colorimetric Calibration Tool".
4. Select the printer model.
5. Make sure that the "READY" message is displayed on the printer LCD, and click
[Next].
6. Select the connected printer from the printer list, and check if the LCD panel
backlight of the printer flashes by clicking [Confirming flashing of the backlight].
7. Click [Next], then the message that prompt you to agitate the ink inside the
cartridges will be displayed.
If the printer has not been used for more than two weeks, it is
C H E C K
P O I N T
recommended to agitate the ink inside the cartridges to get an
accurate result. Remove all the ink cartridges from the printer, and
shake them gently for four or five times.
8. Click [OK] to start the cleaning.
ADJUSTMENT
Figure 5-38. Colorimetric Calibration ID Startup Screen
Head Related Adjustments
Revision D
318