Configuration; Remote Battery Settings - Garmin GPS 155XL Installation Manual

4.3.7

Configuration

Select the Configuration Test Page. Change the selectable Strap and Fuel selections to match that of the aircraft. The
available options are:
Fuel: av gas
jet A
jet B
NOTE:
Strap: Field
lnav 1
lnav 2
common
NOTE:
For ARINC 429 input data, the following applies:
Lnav 1
Lnav 2
common
NOTE:
4.3.8

Remote Battery Settings

Remote Battery: none
instld
NOTE:
Low Battery—Selectable between 8.0 volts and 9.6 volts by 0.2 volt steps
NOTE:
using Aviation gas (5.8 lbs/gal)
Using Jet A/Jet A-1 fuel (6.7 lbs/gal)
Using Jet B (JP-4) fuel (6.5 lbs/gal)
The Fuel option is used to designate the type of fuel used so that the correct fuel density will
be used in calculations.
Description
Number I (Pilot) long range NAV
Number 2 (Co-Pilot) long range NAV
Common long range NAV
The strap option affects the interpretation of ARINC 429 input data.
Only data with SDI=0 or SDI=1 is used
Only data with SDI=0 or SDI=2 is used
Only data with SDI=0 is used
SDI=0 is an "all call".
If "instld" is selected when a battery is not installed, erroneous voltages will be shown on the
Power Test page and invalid battery messages will be issued in normal operating modes.
In normal operating modes, the "Battery Low" message will be issued when the battery
voltage is below the low battery value. The default value is 9.0 volts.
GPS 155Xl/GNC 300XL Installation Manual
P/N 190-00067-22 Rev E Page 4-6