8. Position the center pillar.
9. Plug weld accordingly.
To create a solid weld with minimum heat
Note
distortion make 25-mm (1-in) stitch welds
along the seam with 25-mm (1-in) gaps
between. Then go back and complete the
stitch weld.
10. Stitch the weld sectioning joint.
11. Clean and prepare all welded surfaces.
12. Apply the sealers and anti-corrosion materials
to the repair area, as necessary.
13. Paint and repair the area.
14. Install all related panels and components.
15. Connect the negative battery cable.
16. Enable the SIR system.
Body
© 2008 General Motors Corporation. All rights reserved.
TRAINING
29