Chevrolet Captiva Manual page 26

TRAINING
Centre Pillar Sectioning
Removal Procedure
Section in specified areas only. Sectioning
Note
outside of these areas may compromise the
structural integrity of the vehicle. The door
frame can be replaced at factory seams, but
requires the removal of the windshield and
the roof. The sectioning procedures have
been developed as a more cost-effective
alternative to complete replacement. The
specific area to be sectioned is determined
by the extent of the damage to the vehicle.
1. Disable the supplemental inflatable restraint
(SIR) system.
2. Disconnect the negative battery cable.
3. Remove all related panels and components.
4. Repair as much of the damage as possible to
factory specifications.
Foam sound deadeners must be removed
Note
from areas within 152.4 mm (6 in) of where
flame is to be used for body repairs. When
reinstalling foam sound deadeners, avoid
inhaling fumes as bodily injury may result.
5. Note the location and remove the sealers and
anti-corrosion materials from the repair area, as
necessary.
6. On the original outer door frame, measure down
from the lower edge of the door opening 135
mm (5.3 in) (A) and mark a horizontal line.
Do NOT damage any inner panels or rein-
Note
forcements
7. Cut the panel where sectioning is to be per-
formed
26
© 2008 General Motors Corporation. All rights reserved.
Body