Chevrolet Captiva Manual page 28

TRAINING
3. Drill 8-mm (5/16-in) plug weld holes along the
sectioning cut on the remaining original part.
Locate these holes 13 mm (1/2 in) from the
edge and spaced 40 mm (1½ in) apart.
In any area damaged beyond recognition, or
Note
if structural Weld-Thru adhesive is present,
space the plug weld holes 40 mm (1½ in)
apart.
4. Drill 8-mm (5/16-in) plug weld holes in the serv-
ice part as necessary in the locations noted from
the original panel and along the sectioning cut.
5. Prepare all mating surfaces as necessary.
6. Apply 3M® Weld-Thru coating P/N 05916 or
equivalent, to all mating surfaces.
7. Fit the backing plate halfway into the sectioning
joint, clamp and plug weld to the vehicle.
28
© 2008 General Motors Corporation. All rights reserved.
Body