Table of Contents
Advertisement
Basic operations
STANDBY indicator
OPEN/CLOSE
TOP MENU
ENTER
NOTE
Make sure that the TV - DVD switch on the
remote control unit is set to "DVD" when
TV
DVD
using the 5/∞/2/3 and numeric buttons
for controlling the unit.
About invalid operation icon
When you press a button, and if the unit does not accept its
operation,
appears on your TV screen. Operations are
occasionally unacceptable even if
Note that some operations may not be accepted. For example,
some discs may not allow rapid advance/reverse or slow-
motion playback.
Turning on/off the unit
Press DVD STANDBY/ON
control unit or press
The STANDBY/ON indicator on the front panel, which lights
in red during standby, lights in green.
The opening display appears on the TV screen, and the following
messages may appear at the bottom of the opening display.
NOW READING
Message area
10
0
3
DVD STANDBY/
ON
5/∞
3
DIMMER
is not displayed.
on the remote
on the front panel.
• NOW READING (The unit is reading the disc information.)
• REGION CODE ERROR! (The region code of the DVD VIDEO
disc does not match the unit. The disc cannot be played back.)
• OPEN
• CLOSE
• NO DISC
NOTE
Even if you turn off the unit, the unit is not disconnected from the
AC power source as long as it is connected to the wall outlet. This
state is called standby mode. In this state, the unit consumes a
very small amount of power.
Initial setup
When you turn on the unit for the first time after purchase, the
following message appears on the TV screen.
EXECUTE DVD PLAYER SETUP? - BASIC PICTURE/AUDIO
SETTING
YES - PRESS ENTER
NO - CANCEL
You can set the display language, TV monitor type, analog audio
output and digital output before using the unit, by following the
procedure below.
• Refer to pages 37 and 38 for detailed explanation of each item
to be set in the following procedure.
1
Press ENTER.
The first page of the DVD PLAYER SET UP display appears.
The pull-down menu of the [ON SCREEN LANGUAGE] is
already open.
DVD PLAYER SET UP
MENU LANGUAGE
AUDIO LANGUAGE
SUBTITLE
ON SCREEN LANGUAGE
SELECT
USE 5∞23 TO SELECT, USE ENTER TO CONFIRM
ENTER
ON SCREEN LANGUAGE options
2
Press 5/∞ to select the desired language.
You can select the on-screen language for the preference
displays, etc. from among ENGLISH, SPANISH and
FRENCH.
3
Press ENTER.
The second page is shown, in which the pull-down menu of
the [MONITOR TYPE] is already open.
DVD PLAYER SET UP
MONITOR TYPE
PICTURE SOURCE
SCREEN SAVER
MP3&WMA/JPEG
SELECT
USE 5∞23 TO SELECT, USE ENTER TO CONFIRM
ENTER
MONITOR TYPE options
4
Press 5/∞ to select the desired monitor type.
For a normal (conventional) TV, select [4:3 LB] or [4:3 PS].
For a wide-screen TV, select [16:9 NORMAL] or [16:9 AUTO].
(See page 37.)
ENGLISH
ENGLISH
OFF
ENGLISH
ENGLISH
SPANISH
FRENCH
4:3 L.B.
16:9 NORMAL
16:9 AUTO
AUTO
4:3 LB
ON
4:3 PS
MP3
Advertisement
Table of Contents
