JVC MX-JD8 Service Manual page 36

3.6.2 Removing the front panel assembly
(See Figs.2 and 3)
• Remove the net assembly as required.
(1) Insert the tip of a flat-bladed screwdriver or similar tool into
the space between the front surround speaker main body
and front panel assembly, and lift the front panel assembly
little by little to remove the sections b. (See Fig.2.)
Note:
To prevent damaging the front panel assembly and sur-
round speaker main body, insert cushioning plates etc.
into the space between the surround speaker main body
and front panel assembly. (See Fig.2.)
(2) From the inside of the front panel assembly, disconnect the
wire (white) from the terminal of the speaker. (See Fig.3.)
3.6.3 Removing the speaker
(See Fig.3)
• Prior to performing the following procedures, remove the front
panel assembly.
(1) From the inside of the front panel assembly, disconnect the
wire (white/red) from the terminal of the speaker.
(2) Remove the four screws A attaching the speaker.
(3) Take out the speaker from the front panel assembly.
1-36 (No.MB282)
Front panel assembly
Cushioning
b
plate, etc.
Fig.2
Wire(white/red)
Wire(white)
A
Front panel assembly
Fig.3
Flat-bladed
screwdriver, etc.
Terminal
A
Speaker