JVC MX-JD8 Service Manual page 12

3.1.6 Removing the DVD mechanism assembly
(See Figs.12 and 13)
• Prior to performing the following procedures, remove the metal
cover, tuner and video board.
(1) From the top side of the main body, remove the three
screws M attaching the DVD mechanism assembly on the
center chassis. (See Fig.12.)
(2) From the forward side of the main board, disconnect the
card wires from the connectors (CN11, CN522, CN523,
CN524, CN531). (See Fig.12.)
Reference:
When reassembling, pass the card wire through the sec-
tion f of the main board before connecting the card wire
to the connector CN11. (See Fig.12.)
(3) Remove the spacer fixing the card wires. (See Fig.12.)
Reference:
After connecting the card wires, fix them with the spacer
as before. (See Fig.12.)
(4) From the inside of the main body, take out the DVD mech-
anism assembly.
(5) Remove the tray fitting from the DVD mechanism assembly
in the direction of the arrow. (See Fig.13.)
1-12 (No.MB282)
DVD mechanism assembly
M
Main board
Card wires
f
Card wire
Fig.12
DVD mechanism assembly
Tray fitting
Fig.13
M
Center chassis
Spacer
Card
wires
CN531
CN11 CN522
CN524 CN523