To Connect To Audio Equipment With A Digital Input; To Connect The Power Cord - JVC XV-D721BK Instructions Manual

To connect to an audio equipment with a digital input
You can enhance the sound quality by connecting the unit's DIGITAL output (OPTICAL or COAXIAL) to the digital input
of an amplifier, DAT or MD by using an optional digital cable. The digital audio signal from a disc is directly
transferred. If you connect the unit to a Dolby Digital or DTS decoder or an amplifier with a built-in decoder by using
an optional digital cable, you can enjoy high-quality surround sound.
When you make the digital connection, also make the analog connection, because, depending on the disc type, no
audio may be reproduced from the DIGITAL outputs.
The unit
REAR
FRONT
LEFT LEFT
RIGHT RIGHT
ANALOG
PCM/STREAM
DIGITAL
OPTICAL COAXIAL
AUDIO OUT
Audio cable
(supplied)
• For digital connection, connect the unit's DIGITAL output (OPTICAL or COAXIAL) to the digital input of an audio
equipment using an optional digital cable.
NOTES
• When you connect the unit's DIGITAL output to a digital audio equipment, before using, make the "DIGITAL AUDIO OUTPUT"
setting in the "PREFERENCE 2" on-screen display correctly according to the connected audio equipment. If the "DIGITAL
AUDIO OUTPUT" is not set correctly, loud noise may be generated from speakers, causing damage to your speakers. See
"DIGITAL AUDIO OUTPUT" on page 42.
• When you connect the unit's DIGITAL output to a Dolby Digital or DTS decoder (or amplifier with a built-in decoder) to enjoy
surround sound, the unit's "COMPRESSION" setting in the "PREFERENCE 2" on-screen display and all settings in the "SPK.
SETTINGS" display are invalid. Make appropriate surround audio settings by the decoder.

To connect the power cord

When all the audio/video connections have been made, insert the smaller plug of the supplied AC power cord to the
unit's AC IN connector, then insert the other end to the wall outlet. Make sure that plugs are inserted firmly. The
STANDBY indicator lights and setup is completed.
Warning
• Disconnect the power cord if you are not going to use the unit for a long time.
• Disconnect the power cord before cleaning the unit.
• Disconnect the power cord before moving the unit.
• Do not connect or disconnect the power cord with wet hands.
• Do not pull the power cord when disconnecting it, as this may damage the cord and cause fire, electric shock, or
other accidents.
Caution
• Do not damage, alter, twist, or pull the power cord, as this may cause fire, electric shock, or other accidents.
• To prevent any accidents or damages caused by an unsuitable AC power cord, only use the supplied power cord. If
the cord is damaged, contact a dealer and get the new power cord.
• Do not put anything heavy, or the unit, on the power cord, as this may cause fire, electric shock, or other accidents.
When using the DIGITAL OUT (OPTICAL) jack, remove the
protection cap. Do not lose the removed cap.
When the jack is not used, fix the protection cap into the jack.
CENTER
SUBWOOFER
VIDEO S-VIDEO Y P
B
COMPONENT
AV COMPU LINK VIDEO OUT
Optical digital cable
(not supplied)
P SCAN MODE
R
525p 525i
Coaxial digital cable
(not supplied)
Digital equipment
IN
White
LEFT
RIGHT
Red
Getting started
IN
AUDIO
OPTICAL COAXIAL
DIGITAL
16