FOllOw inStructiOnS MaY reSult in PrOPertY daMage, bOdilY injurY, Or even death. FOr uSe in the u.S. and canada. Suitable FOr inStallatiOn in MObile hOMeS. iF thiS harMan StOve iS nOt PrOPerlY inStalled, a hOuSe Fire MaY reSult. FOr YOur SaFetY, FOl- lOw inStallatiOn directiOnS.
Before re-using the appliance, have the venting system thoroughly inspected and replace any damaged components. The glass in your Harman stove is a special ceramic glass. • dO nOt abuse the glass by striking or slamming the door.
Page 3
Maintenance Scraping the burn pot: Whenever adding fuel to the hopper, take the time and scrape the grate surface of the burnpot, using the scraper tool provided. This can be done while a fire is burning. Wearing heat resistant gloves, open the firebox door. Scrape any accumulated ashes from in front of the fire, into the ash pan. Now, scrape under the fire, in a downward direction, to loosen any carbon deposits. Do not scrape the fire out of the...
Page 4
Maintenance 6. Remove the ash pan and properly dispose of the Burn pot ashes. Clean-out 7. Remove combustion blower cover by turning the plate blower cover latch vertical, see Fig.26. Sliding the cover out of the slot on the left.This will expose the combustion blower wheel and flue outlet, Fig.27.
Page 5
P43 Maintenance - burn Pot burn Pot cleaning and Maintenance 1. Scrape the top holed surface and sides of the burn pot.(Fig ) It is not necessary to completely remove all material from the burn pot. The excess will be pushed out during the next use.
P43 Maintenance - cleaning the Feeder body Pellet fines may accumulate in the feeder body over a period of time; therefore, a yearly inspection and cleaning of this area must be performed. To clean out fines: 5/16" Hex Head 5/16" Hex Head Screws (2 on 1. Remove the rear cover panels.
P43 trouble-Shooting StOve dOeS nOt Feed SMOKe iS viSible cOMing Out OF vent 1. No fuel in hopper. 1. Air-fuel ratio is too rich. 2. Firebox draft may be too low for sensing switch in A. Feed rate too high.