JVC TH-A55 Instructions Manual page 20

Getting started
For TV operations
You can operate your TV using the remote control supplied with
this system.
• Refer also to the instruction manuals supplied with your TV.
% To set the manufacturer's code
You can operate a JVC TV without setting the remote control
signal.
1
Press TV.
2
Press and hold . TV.
Keep the button pressed until step 4 is finished.
3
Press ENTER.
17
4
Press number buttons (1-9, 0) to enter
the manufacturer's code (2 digits).
Examples:
For a Hitachi TV: Press 1, then 0.
For a Toshiba TV: Press 0, then 8.
(play button)
5
Release . TV.
6
Try operating your TV by pressing
. TV.
When your TV turns on or off, you have entered the correct
code.
If there is more than one code listed for corresponding brand,
try each one until you enter the correct one.
Number buttons
NOTE
• Manufacturers' codes are subject to change without notice. If they are
changed, this remote control cannot operate the equipment.
• Set the codes again after replacing the batteries of the remote control.
% Operation
IMPORTANT
Before using the remote control to operate a TV;
• Press TV.
The following buttons are available:
. TV:
TV VOL +/–:
TV/VIDEO:
CHANNEL +/–:
1-10, 0, +10 (100+): Selects the channel.
TV RETURN:
For DBS tuner or CATV converter
operations
You can operate your DBS tuner or CATV converter using the
remote control supplied with this system.
• Refer also to the instruction manuals supplied with your DBS
tuner or CATV converter.
% To set the manufacturer's code
1
Press CATV/DBS.
2
Press and hold . VCR/DBS.
Keep the button pressed until step 4 is finished.
3
Press ENTER.
Manufacturer Code
JVC 01
Hitachi 10
Magnavox 02
Mitsubishi 03
Panasonic 04, 11
RCA 05
Turns TV on and off.
Adjusts the volume.
Selects the input mode (either TV or
VIDEO).
Changes the channels.
Alternates between the previously selected
channel and the current channel.
Manufacturer Code
Samsung 12
Sanyo 13
Sharp 06
Sony 07
Toshiba 08
Zenith 09