To Connect To Audio Equipment With A Digital Input - JVC LET0141-002A Instructions Manual

Getting started

To connect to audio equipment with a digital input

Connection to an amplifier/receiver with digital input, Dolby Digital decoder/amplifier with
built-in Dolby Digital decoder, or an amplifier with built-in DTS and Dolby Digital decoder
You can enhance the sound quality by connecting the unit's DIGITAL OUT (coaxial or optical) with the digital input of
an amplifier, DAT or MD by using a digital cable. The digital stereo audio signal from a disc is directly transferred.
And, if you connect with a Dolby Digital decoder or an amplifier with built-in Dolby Digital decoder by using a coaxial
or optional digital cable, you can enjoy high-quality audio and surround sound. The unit also is compatible with the
DTS function. When you make a digital connection, leave the 2 channel analog audio connection as it is. Otherwise,
depending on the disc type, no audio may be reproduced.
VIDEO OUT
VIDEO S-VIDEO Y P
B
COMPONENT
FRONT REAR
LEFT
RIGHT
ANALOG
Red
• For digital connection, connect the unit's DIGITAL out (coaxial or optical) to the digital input of a Dolby Digital
decoder or an amplifier with built-in Dolby Digital decoder using an optional digital cable.
NOTES
¶
DTS (Digital Theater System)
DTS is a newly-developed surround system which can handle more amount of data than Dolby Digital, providing
better audio quality.
Though the number of audio channels is 5.1 which is same as Dolby Digital, DTS provides fat sound and better
signal-to-noise ratio, thanks to the lower audio compression ratio format. It also provides wide dynamic range
and better separation, resulting magnificent sound.
¶
When you connect the audio equipment with a digital input, before using, change the "DIGITAL AUDIO OUTPUT"
setting in the "PREFERENCE 2" on-screen display according to the connected audio equipment with a digital
input. When the "DIGITAL AUDIO OUTPUT" setting is not set correctly, loud noise may be played back from
speakers, and it cause of the breakdown of your speakers. See "DIGITAL AUDIO OUTPUT" on page 56.
¶
With this connection, the unit's settings for "COMPRESSION" and "DOWN MIX" in the "PREFERENCE 2" on-
screen display and the "SPK.SETTING" on screen display are invalid. Settings for these items must be made
from the decoder.
20
The unit
P
R
AV COMPU LINK
CENTER
PCM/STREAM
OPTICAL COAXIAL
SUBWOOFER
DIGITAL
AUDIO OUT
White
Audio cable
(supplied)
Coaxial digital cable
(not supplied)
Optical digital cable
(not supplied)
IN
Red
RIGHT
AUDIO
LEFT
White
Amplifier/receiver with digital input,
Dolby Digital decoder/amplifier with
built-in Dolby Digital decoder, or an
amplifier with built-in DTS and Dolby
Digital decoder
IN
COAXIAL
DIGITAL
OPTICAL