Install The Camera - JVC WB-S681U Instructions Manual

WB-S682U Wall Mount
Notes on Installation
● Check that the installation location is able to withstand the total weight of the camera, which is about 2.9 kg, before
you install. If the location is not strong enough, reinforce with a reinforcing board.
● Always use a wire rope to install.
● Screws to secure WB-S682U to the wall are not provided. Use the appropriate screws based on the materials,
structure and total weight of the installation location.
● Conform to the local standards during the installation or construction.
Screws ( 5 mm~ 6 mm)
or
Bolts (M4~M6)
1.
Make a hole on
the wall.
2.
Thread a cable
through
WB-S682U.
3.
Mount WB-S682U
on the wall.
(4 locations)
4.
Install the wire rope.
Making a hole
on the wall
Screw position
x 4
21 ( )
83.5 (3- )
6.
Front side of camera
3.
4.
Screw (M4)
6.
Screws (M4)
(Accessory)
Fall prevention
6 mm
CAUTION
Take note of the length, strength, pull
and material of the wire rope to be used.
Hexagon cap nut (M4)
(Accessory)
Wire rope
5.
6.
5.
Ceiling attachment fitting
7.
below 6 mm
below 9 mm
4~5.5 mm
1.
2.
30 mm
Connect the cable.
Connect the cable to the
terminal block of the ceiling
attachment fitting.
Mount the ceiling
attachment fitting on
WB-S682U. (3 locations)
Secure with the hexagon cap nut.
(3 locations)

Install the camera.

(For details, refer to the
Instruction Manual of the camera.)
When a hole cannot be
made on the wall