Roberts Gorden Blackheat BH15UT Installation, Operation & Service Manual page 40

®
B I
LACKHEAT NSTALLATION
Step 7.8.1 Reflector, U-Clip and Reflector Support Installation
The pictorial drawings of the heater construction in
Section 6 are schematic only and provide a general
guideline of where hangers, reflector supports and
U-clips are to be installed.
To ensure proper expansion and contraction movement of
the reflectors, a combination of U-clips and reflector
Description
Reflector Support Package
Wire Form
Reflector Support Strap
Screw #8 x 3/4 (3.9 x 19 mm)
U-Clip Package
Reflector End Cap
34 of 75
O S M
PERATION AND ERVICE ANUAL
Part Number
03050010
91908004
03050000
94320812
91107720
027508XX
supports are used. The positioning of reflector supports
and U-clips depend on the individual installation. Use
either pop rivets or sheet metal screws instead of U-clips
when installing end caps and joint pieces in areas where
impact and high wind may be a factor. The following rules
must be observed: