Gpl Declarations; Safety Information - NComputing N400 User Manual

GPL Declarations

The NComputing N-series access device contains – in part – some free software (software licensed in a
way that ensures your freedom to run, copy, distribute, study, change and improve the software). This
free software is also contained in the N-series firmware update files that are distributed online. The free
software contained within the N-series firmware includes a version of X-LOADER, U-BOOT, LINUX,
LIBSYSFS, LIBUCI, LIBUSBIP, ETHTOOL, UCLIBC, QT and BUSYBOX.
Further, for at least three (3) years from the date of distribution of the applicable product or software,
we will give to anyone who contacts us at gplcoderequest@ncomputing.com, for a charge of no more
than our cost of physically performing source code distribution, a machine-readable copy of the
complete corresponding source code for the version of the software that we distributed to you. For
additional information refer to this page on the NComputing website:
www.ncomputing.com/gplcodedownload
Refer to the following to prevent any physical injury or loss of assets caused by damage to the product.
A user must read this User Manual carefully before use and properly follow the instructions.

Make sure that the place of installation is not too hot (above 35˚C), too cold (below 0˚C), or too
wet (above 85% relative humidity).

Avoid any severe impacts to the product

Make sure that the product is not exposed to direct sunlight or any hot machinery.

Please keep the product away from any items which have strong magnetic properties.

Do not disassemble, repair or rebuild the product.

Please properly route all cables and power cords to avoid a tripping hazard. An electric shock,
fire, damage to the product or physical injury may occur as a result of tripping over the cable.
Page 5 of 25

Safety Information

NComputing N-series User Manual rev11.09.12