Service lid installation
1. Install the service lid 1, and then insert a
rivet completely in the holes in both the
service lid 1 and inner hull 2.
2. Push in the rivet pin 3 until it clicks and
is flush with the top of the rivet.
3
1
2
3. When removing a rivet, push the rivet pin
3 in until it clicks and is below the top of
the rivet.
4. When reinstalling a rivet, hold the rivet
flange a with both hands and push the
rivet pin perpendicularly against a hard
flat surface until the pin protrudes from
the top of the rivet.
a
3
Hinge assy. check
1. Fully open the front hood and check that
it remains in the open position. If the front
hood cannot remain in the open position,
replace the hinge assy.
Hood lock check
1. Fully close the front hood and check that
it latches securely. If the front hood can-
not latch securely, check that the hood
lock is installed properly.
2. Check the hood lock. Replace if cracked
or damaged.
Front hood
1
2
3
4
5
6
7
8
9
A
8-10