Yamaha WaveRunner VX 700 Service Manual page 146

HULL
HOOD
d
6
c
<
c d
Handlebar holder bolt 7:
20 N·m (2.0 kgf·m, 14.8 ft·lb)
TIP:
• Do not route the left handlebar switch lead
1 and throttle cable 3 between the han-
dlebar 5 and the steering master 4.
• The upper handlebar holder 6 should be
installed with the punch mark e facing
down.
• Tighten the bolts 7 so that there is clear-
ance between the steering master 4 and
the upper handlebar holders 6 at both
ends of the upper handlebar holders.
• Make sure that clearance c is narrower
than clearance d.
4. Install the throttle lever assy. 8, and
then tighten the bolts 9 to the specified
torque.
g
Throttle lever assy. bolt 9:
3 N·m (0.3 kgf·m, 2.2 ft·lb)
TIP:
Align the projection f on the throttle lever
assy. with the handlebar hole g.
8-5
Hull and hood
6
d
e
c
5
9
f
8
8
5. Install the left handlebar switch assy. 0,
and then tighten the screws A to the
specified torque.
A
Left handlebar switch screw A:
3 N·m (0.3 kgf·m, 2.2 ft·lb)
TIP:
Align the projection h on the handlebar
switch assy. with the handlebar hole k.
6. Install the throttle cable end into the
throttle lever.
7. Fit the seal m into the groove in the
bracket.
8. Pull the throttle cable 3 in the direction
of the arrow shown.
9. Adjust the throttle lever free play p. See
"Throttle lever free play check" (3-2).
0
k
h
0
m
3