Felcom 15 - Furuno RC18xx Series User Manual

6. RC1840 Equipment Installations
6.4 Felcom 15 Installation
Refer to Installation Manual, Felcom 15
6.4.1 IC-215 Communications Unit/Display
1) Mount the IC-215 in the front, desktop area, of the console on the right side.
Using the four tapping screws provided.
(Refer to Pg. 2-3, the RC1840 Mechanical Layout and Pg. 8 of the
Installation Manual)
2) Connect the cables for the Felcom 15 Printer, Keyboard,
Felcom 15 Junction Box and Felcom 15 Power. These cables have
been installed and labeled within the console.
3) Install the IC-305, Distress Alert/Received Call Unit, on the bridge.
Wire this to the IC-315 Junction box using Belden 85164 or equivalent.
(Refer to Pg. S-6, the Felcom 15, IC-315 Junction Box Connections)
4) Install the IC-306, Alarm Unit, near the console.
Wire this to the IC-315 Junction box using Belden 85164 or equivalent.
(Refer to Pg. S-6, the Felcom 15, IC-315 Junction Box Connections)
6.4.2 IC-115 Antenna Unit
1) Install Antenna Unit, IC-115, (refer to the Installation Manual). Make sure
that the Antenna Unit is properly grounded and that all connections are properly
sealed. Route the antenna cable to the IC-215 and connect it to the ANT port.
(Refer to Pgs. 1 through 7 in the Installation Manual, Felcom 15)
6-4