Manual Configuration - Netopia Fast EtherTX-10 User Manual

Note: Add New Hardware will not detect the card if you have installed
Windows 95 after the card was already in the computer. There are two
ways to work around this:
I
Move the card to another PCI bus master slot, restart the
computer, and reinstall the driver.
I
Reconfigure your computer with the following procedure:
1. Double-click My Computer, then Control Panel, then System.
2. Click the Device Manager tab.
3. Select Other Devices (question mark icon).
4. Select PCI Ethernet Controller.
5. Click the Remove button.
6. In the Confirm Device Removal window, click OK.
7. Close the Control Panels and restart your computer.
8. When the New Hardware Found window appears, follow the
instructions for installing the driver on page 12 of this
manual.
N
ETWORK SERVICES ARE NOT AVAILABLE TO YOUR
Verify that Ethernet is selected in the AppleTalk control panel and
AppleTalk is Active in the Chooser.
M
ANUAL CONFIGURATION
If you want to manually set up your PCI card for a particular network
environment, you can configure the card by assigning speed and
duplex settings. Manual configuration is different depending on
whether you are operating under Windows or the MacOS. Please refer
to the appropriate section below.
Operation and Troubleshooting
M OS
AC COMPUTER
21