Exit Off Early Jam - Xerox Phaser 3010 Service Manual

Exit Off Early Jam

Phaser 3010/3040/WorkCentre 3045 Service
The paper passed through the Exit Sensor earlier than the specified time, or did
not pass through the Exit Sensor within the specified time.
Warning
Allow the Fuser to cool before servicing the printer.
Applicable Errors
• 077-108: Exit Off Early Jam
• 077-109: Exit Off Jam
Initial Actions
• Check the media path for obstructions or debris.
• Cycle printer power.
• If the problem persists, use the following procedure.
Troubleshooting Reference Table
Applicable Parts
Fuser, PL5.1.1
■
MCU Board, PL7.1.3
■
Troubleshooting Procedure Table
Step Actions and Questions
1 Check P/J18 on the MCU Board.
Is P/J18 connected securely.
2 Replace the Fuser (page 4-38).
Does the error persist?
Xerox Internal Use Only
Error Troubleshooting
Wiring and Plug/Jack Map References
"Map 2" on page 7-4
■
"Fuser" on page 7-18
■
Yes
Go to Step 2.
Replace the
MCU Board
(page 4-43).
No
Secure P/J18.
Complete.
2-101