Accessories Warning; Maintenance - Milwaukee M12PCG Operator's Manual

Using the Control Switch
The control switch may be set to two positions:
forward and rack release.
For forward, push in the control
switch from the right side of the tool.
The tool will run normally.
To lock the trigger and release the
rack, push in the control switch from
the left side of the tool. The rack
can be moved to the desired posi-
tion. The trigger will not work while
the control switch is in the locked
position. Always lock the trigger
or remove the battery pack before
performing maintenance, changing
accessories, storing the tool and
any time the tool is not in use.
accessories
Warning
before changing or removing accessories.
Only use accessories specifically recom-
mended for this tool. Others may be hazardous.
For a complete listing of accessories, refer to your
MILWAUKEE Electric Tool catalog or go online to
www.milwaukeetools.com.au /
www.milwaukeetools.co.nz. To obtain a catalog,
contact your local distributor or service center.
FORWARD
RACK
RELEASE
Always remove battery pack

mainTenance

Warning
always unplug the charger and remove the bat-
tery pack from the charger or tool before per-
forming any maintenance. Never disassemble
the tool, battery pack or charger. Contact a
milWaukee service facility for ALL repairs.
Maintaining Tool
Keep your tool, battery pack and charger in good
repair by adopting a regular maintenance program.
After six months to one year, depending on use,
return the tool, battery pack and charger to
MILWAUKEE service facility for:
• Lubrication
• Mechanical inspection and cleaning (gears,
spindles, bearings, housing, etc.)
• Electrical inspection (battery pack, charger,
motor)
• Testing to assure proper mechanical and electrical
operation
If the tool does not start or operate at full power
with a fully charged battery pack, clean the contacts
on the battery pack. If the tool still does not work
properly, return the tool, charger and battery pack,
to a MILWAUKEE service facility for repairs.
Warning
sonal injury and damage, never immerse your
tool, battery pack or charger in liquid or allow
a liquid to flow inside them.
Cleaning
Clean dust and debris from charger and tool
vents. Keep tool handles clean, dry and free of oil
or grease. Use only mild soap and a damp cloth
to clean the tool, battery pack and charger since
certain cleaning agents and solvents are harmful to
plastics and other insulated parts. Some of these
include , turpentine, lacquer thinner, paint
thinner, chlorinated cleaning solvents, ammonia
and household detergents containing ammonia.
Never use flammable or combustible solvents
around tools.
Repairs
For repairs, return the tool, battery pack and
charger to the nearest service center, please visit
www.milwaukeetools.com.au /
www.milwaukeetools.co.nz or contact our
customer service centre (Australia Toll Free
Telephone Number 1300 361 505) (New Zealand
Toll Free Telephone Number 0800 279 624).
5
To reduce the risk of injury,
To reduce the risk of per