general poWer Tool safeTy Warnings Warning read all safeTy Warnings and all insTrucTions. Failure to follow the warnings and instructions may result in electric shock, fire and/or save all warnings and instructions for future reference. serious injury. The term "power tool" in the warnings refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. • R emove any adjusting key or wrench before Work area safeTy turning the power tool on. A wrench or a key left • K eep work area clean and well lit. Cluttered or attached to a rotating part of the power tool may dark areas invite accidents.
• M aintain labels and nameplates. These carry WARNING Always remove battery important information. If unreadable or missing, contact a MILWAUKEE service facility for a free pack before changing or removing replacement. accessories or cartridges. • W ARNING Some dust created by power sanding,...
Installing the Carriage or Barrel 7. Push the rod handle forward until the piston is against the pack. for the M12 Caulk and Adhesive Gun. Other rods 8. Push the control switch to the Forward position. and carriages may cause damage to the tool. OPERATION Place the carriage over the piston and rod.
MILWAUKEE service facility for repairs. For a complete listing of accessories, refer to your MILWAUKEE Electric Tool catalog or go online to Warning To reduce the risk of per www.milwaukeetools.com.au / sonal injury and damage, never immerse your www.milwaukeetools.co.nz.
Page 6
Milwaukee Electric Tool Corporation (Australia) Techtronic Industries (Australia) Pty. Ltd. Doncaster, Victoria, Australia, 3108 Milwaukee Electric Tool Corporation (New Zealand) Techtronic Industries (New Zealand) Pty. Ltd. Mt Wellington, Auckland, New Zealand, 1060 Professionally made in China for Milwaukee Electric Tool Corporation 961075292-01(A)