E-Mu Classic keys Operation Manual page 20

IF CLASSIC KEYS IS NOT
RESPONDING PROPERLY OR
PLAYS THE WRONG PRESET,
MAKE SURE THAT CLASSIC
KEYS AND YOUR MIDI
CONTROLLER ARE SET TO
THE SAME MIDI CHANNEL
AND THAT THE MIDI
VOLUME IS TURNED UP.
FOR MORE INFORMATION
ABOUT MIDI, SEE MIDI
REALTIME CONTROLS ON
PAGE 60.
CHANNEL PAN SHOULD
NORMALLY BE SET TO "P"
UNLESS REALTIME CONTROL
OF PANNING IS DESIRED.
THIS WILL ALLOW THE PAN
SETTINGS PROGRAMMED
FOR EACH PRESET TO BE
USED.
18
BASIC OPERATION
MIDI CHANNEL SELECTION
Press the cursor key repeatedly until the
cursor is underneath the channel num-
ber. (The cursor is a little flashing line
underneath one of the parameters in the
display.) Rotate the data entry control to
select MIDI channel 01-16. As the chan-
nel is changed, the display will change to
show the preset, volume and pan associ-
ated with the displayed channel.
C01 Vol127 Pan=P
0
000 Preset Name
PRESET SELECTION
Press the cursor key repeatedly until the
cursor is underneath the preset number.
(The cursor is a little flashing line under-
neath one of the parameters in the
display.) As the data entry control is
rotated, the preset number and name will
change. The displayed preset will be
assigned to the displayed MIDI channel.
Preset numbers are arranged into four
banks of 128.
C01 Vol127 Pan=P
0
000 Preset Name
PRESET BANK SELECTION
You can jump between preset banks by
following the steps outined below.
1. Press and Hold the Home/Enter
button. While holding the button, turn
the data entry knob.
2. Turning the knob will cause the preset
to jump to the same location in the
next bank.
CHANNEL VOLUME
Press the cursor key repeatedly until the
cursor is underneath the volume value.
Rotate the data entry control to select
volume 00-127. (This is the same param-
eter as MIDI volume control #7, and
changes made over MIDI will be shown in
the display.)
C01 Vol127 Pan=P
0
000 Preset Name
CHANNEL PAN
Press the cursor key repeatedly until the
cursor is underneath the pan value.
Rotate the data entry control to select pan
values -7 to +7 or "P". When "P" is
selected, the pan value specified in the
preset is selected. Any other value will
override the pan parameter in the preset.
(This is the same parameter as MIDI pan
control #10, and changes made over MIDI
will be shown in the display.)
C01 Vol127 Pan+7
0
000 Preset Name
The bank selection feature allows you to jump
between banks of 128 presets.