Fujitsu PRIMERGY TX1310 M1 Operating Manual page 53

– System already installed:
Ê Switch the power switch to ON (I), see
Ê Press the On/Off button (see item 1 in figure
The server is switched on, performs a system test and boots the
operating system.
Switching the server off
Ê Shut down the operating system properly.
The server is switched off automatically and goes into standby mode.
I
If the operating system does not switch off the server automatically, press
the On/Off button for at least four seconds and/or send a corresponding
control signal.
Other Power On/Off options
I
The usage of Power On/Off options requires the installation of
ServerView Agents.
Besides the On/Off button, the server can be switched ON and OFF in the
following ways:
– Timer-controlled switch-on/off
Using the ServerView Operations Manager, you can configure that the
server is switched on/off controlled by timer.
– Ring indicator
The server is switched on by an internal or external modem.
– Wake up On LAN (WOL)
The server is switched on by a command via the LAN (Magic Packet
(LAN1 only).
– After power failure
The server automatically reboots following a power failure (depending on the
settings in the BIOS).
TX1310 M1
figure 7 on page
Operating Manual
Starting up and operation
52.
5 on page 48).
TM
)
53