Motorola WT4070 User Manual page 81

Troubleshooting the Wearable Terminal (Continued)
Table 4-1
Problem
The wearable Scanning
terminal does not application is not
accept scan input. loaded.
Unreadable bar
code.
Distance between
exit window and bar
code is incorrect.
Wearable terminal
is not programmed
for the bar code.
Wearable terminal
is not programmed
to generate a beep.
Battery is low.
Wearable terminal Headset adapter
goes into IPL mode without a headset is
after cold boot. connected to the
wearable terminal
during a cold boot.
Scanner trigger is
held down during a
cold boot.
P1 or P2 key is held
down during a cold
boot.
If all three LEDs are lit Voice Only WT4090
solid. is in IPL mode.
WLAN connection is Microsoft security
lost when the feature prevents
wearable terminal is connection to two
connected to a host separate networks.
computer using
ActiveSync.
Cause
Verify that the unit is loaded with a scanning application. See the
System Administrator.
Ensure the symbol is not defaced.
Ensure wearable terminal is within proper scanning range.
Ensure the wearable terminal is programmed to accept the type of
bar code being scanned.
If a beep on a good decode is expected and a beep is not heard,
check that the application is set to generate a beep on good decode.
If the scanner stops emitting a laser beam when the trigger is
pressed, check the battery level. When the battery is low, the
scanner shuts off before the wearable terminal low battery condition
notification.
Note: If the scanner is still not reading symbols, contact the
distributor or Motorola.
Disconnect the headset adapter prior to performing a cold boot.
Update to a newer operating system (OEM version 05.30.0000 or
higher).
Do not press trigger during a cold boot.
Do not press the P1 or P2 key during a cold boot.
Perform cold boot. See
2-17.
Disconnect from the WLAN network prior to connecting to a host
computer using ActiveSync.
Maintenance & Troubleshooting
Solution
Resetting the Wearable Terminal on page
4 - 9