Bridge Mode - D-Link DSL-G624T User Manual

Bridge Mode

For Bridged connections it will be necessary for most users to install additional software on any computer
that will use the Router for Internet access. The connection software normally requires the user to enter the
User Name and Password for the ISP account. This information is stored on the computer, not in the Router.
To configure a Bridge Mode type connection for the WAN, follow these steps:
1. Click the Static IP Address radio button in the WAN Settings section.
2. Under the WAN Connection Setting at the top of the menu should not be changed unless you have
been instructed to change them. However, if you are instructed to change the VPI or VCI values,
type in the values assigned for your account. Leave the PVC and Virtual Circuit setting at the
default (Pcv0 and Enabled) values for now. This can be used later if you are configuring multiple
virtual circuits for your ADSL service. For more information on WAN Connection Setting, see the
table on page 33 below.
3. Under the Static IP heading, choose the Connection Type from the pull-down menu. This defines
both the connection type and encapsulation method used for your ADSL service. The available
options are 1483 Bridged IP LLC, 1483 Bridged IP VC-Mux, 1483 Routed IP LLC, 1483 Routed IP
VC-Mux or IpoA. If you have not been provided specific information for the Connection Type
setting, leave the default setting.
DSL-G624T Wireless ADSL Router User Guide
ADSL Setup menu for Bridge Mode
32