Main Battery Removal; Safe System Shutdown/Re-Boot - Motorola MC21XX SERIES Integrator Manual

1 - 6 MC21XX Series Integrator Guide

Main Battery Removal

CAUTION
To remove the main battery from an MC21XX:
If the MC21XX is in suspend mode, press the Power button to wake the MC21XX.
1.
Press the Power button to place the MC21XX in suspend mode.
2.
On the MC2180, tap Safe Battery Swap.
3.
On the MC2100, using the navigation pad, scroll down to Safe Battery Swap. Press the Enter key.
Wait for the LED Indicator to turn red and then turn off.
4.
Using thumbs, push the two battery latches up. The battery ejects slightly.
5.
Release Latches
Figure 1-6
Remove the battery from the MC21XX.
6.
CAUTION

Safe System Shutdown/Re-boot

To ensure that data is not lost or that system corruption does not occurs, the user must follow the Safe Battery
Swap procedure when replacing the battery. See
procedure is not followed, a Improper Shutdown message appears on the screen.
When removing the battery, follow the Safe Battery Swap procedures below otherwise loss of data or
system corruption may occur. An error message, Improper Shutdown, displays on the screen
indicating that the MC21XX was not shutdown properly.
When in Safe Battery Swap mode, the MC21XX goes into a low power suspend state. All wakeup are
disabled.
Replace the new battery within five minutes to prevent loss of data.
Main Battery Removal on page 1-6. If the Safe battery Swap