Rheem Electric Water Heater Warranty - (Australia Only) - Rheem 310 Series Service Instructions Manual

Rheem Electric Water Heater Warranty - (Australia Only)

1. This warranty is applicable only to water heaters
manufactured from 1
2.
The water heater must be installed in accordance
with the Rheem
instructions, supplied with the water heater, and in
accordance with all relevant statutory and local
requirements of the State in which the water
heater is installed.
3.
Where a failed component or water heater is
replaced under warranty, the balance of the
original warranty period will remain effective. The
replaced part or water heater does not carry a new
warranty.
4. Where the water heater is installed outside the
boundaries of a metropolitan area as defined by
Rheem or further than 25 km from a regional
Rheem branch office, or an Accredited Service
Agent, the cost of transport, insurance and
travelling costs between the nearest Rheem
REPAIR AND REPLACEMENT WORK WILL BE CARRIED OUT AS SET OUT IN THE RHEEM WATER HEATER
WARRANTY ABOVE HOWEVER THE FOLLOWING EXCLUSIONS MAY CAUSE THE WATER HEATER WARRANTY
TO BECOME VOID AND MAY INCUR A SERVICE CHARGE AND / OR COST OF PARTS.
a) Accidental damage to the water heater or any
component, including: Acts of God; failure due to
misuse; incorrect installation; attempts to repair the
water heater other than by a Rheem Accredited
Service Agent or the Rheem Service Department.
b) Where it is found there is nothing wrong with the
water heater; where the complaint is related to
excessive discharge from the temperature and / or
pressure relief valve due to high water pressure;
where there is no flow of hot water due to faulty
plumbing; where water leaks are related to
plumbing and not the water heater or water heater
components; where there is a failure of gas,
electricity or water supplies; where the supply of
gas, electricity or water does not comply with
relevant codes or acts.
c) Where the water
component has failed directly or indirectly as a
result of: excessive water pressure; excessive
temperature and / or
overflow / vent drain; corrosive
SUBJECT TO ANY STATUTORY PROVISIONS TO THE CONTRARY, THIS WARRANTY EXCLUDES ANY
AND ALL CLAIMS FOR DAMAGE TO FURNITURE, CARPETS, WALLS, FOUNDATIONS OR ANY OTHER
CONSEQUENTIAL LOSS EITHER DIRECTLY OR INDIRECTLY DUE TO LEAKAGE FROM THE WATER
HEATER, OR DUE TO LEAKAGE FROM FITTINGS AND / OR PIPE WORK OF METAL, PLASTIC OR
OTHER MATERIALS CAUSED BY WATER TEMPERATURE, WORKMANSHIP OR OTHER MODES OF
FAILURE.
Rheem Australia Pty Ltd
A.B.N 21 098 823 511
NOTE: Every care has been taken to ensure accuracy in preparation of this publication. No liability can be accepted for any
TM025 Rheem Heat Pump Service Instructions REV: B
Date of Issue: 02/08/07
This document is stored and maintained electronically by
WARRANTY CONDITIONS
st
September 2006.
water heater installation
WARRANTY EXCLUSIONS
heater or water
thermal input; blocked
consequences, which may arise as a result of its application.
Service. All printed copies not bearing this statement in RED are deemed "uncontrolled".
Accredited Service Agent's premises and the
installed site shall be the owner's responsibility.
5.
Where the water heater is installed in a position
that does not allow safe, ready access, the cost
of accessing the site safely, including the cost of
additional materials handling and / or safety
equipment, shall be the owner's responsibility.
6. The warranty only applies to the water heater and
original or
replacement parts and therefore does not cover
any plumbing or electrical parts supplied by the
installer and not an integral part of the water
heater, e.g. pressure limiting valve; isolation
valves; non-return valves; electrical switches;
pumps or fuse.
7. The water heater must be sized to supply the hot
water demand in accordance with the guidelines
in the Rheem water heater literature.
from the water heater.
d) Where the water heater is located in a position
that does not comply with the Rheem water
heater installation
statutory requirements, causing the need for
major dismantling or removal of cupboards, doors
or walls, or use of special equipment to bring the
water heater to floor or ground level or to a
serviceable position.
e) Repair and / or replacement of the water heater
due to scale formation in the waterways or the
effects of either corrosive water or water with a
high chloride or low pH level when the water
heater has been connected to a scaling or
corrosive water supply or a water supply with a
high chloride or low pH level as outlined in the
heater Owner's Guide
booklet.
f)
Breakage of collector glass for any reason
including hail damage. (We suggest that the
collector glass be covered by your home
insurance policy).
66
genuine (company)
instructions
and Installation
FOR SERVICE TELEPHONE
131 031 AUSTRALIA
or refer local Yellow Pages
component
or relevant
Instructions