Desa M36E(B,H) Owner's Operation And Installation Manual page 17

6. Repeat process for opposite door as-
sembly.
7. To adjust doors, slide them partially open.
Using a screwdriver, loosen hold-down
screws in the spring clip (see Figure 34)
and pivot plate.
8. Close both doors until evenly joined at
the middle and note gap at outer edges
of face.
9. Reopen one door at a time and retighten
upper and lower hold-down screws.
10. Repeat process until both doors are even-
ly joined, spaced and working freely.
CAUTION: The glass pan-
els become very hot while the
appliance is operating. Do not
attempt to adjust or clean the
glass doors until the appliance
has fully cooled.
The doors may be removed for replacement
or cleaning as follows:
1. Partially open door and press up on upper
spring clip with a screw driver until outer
top pivot pin is free of clip.
2. Fully fold frame assembly and slide upper
edge towards center of firebox opening
until guide pins are free of frame rail (see
Figure 35).
CAUTION: Always operate
the appliance with the doors ei-
ther fully opened or fully closed.
Operating the appliance with
the doors partially open can re-
sult in improper venting of flue
products.
108796-01T
INstallatIoN
Continued
Spring
Clip
Side
Front
Face
Partially
Opened
Door
Fold Bi-Fold
Door After
Releasing
Spring Clip
and Slide
Door Out of
Upper Track
Figure 35 - Removing Glass Doors
OPENING VENT DAMPER
Vent damper must be locked in the full open
position before operating fireplace. If vent
damper is not open, fireplace will not light.
www.desatech.com
Figure 34 - Adjusting Glass Doors
Spring Clip
Remove Bottom Pin
From Pivot Plate While
Sliding Door Out of the
Upper Track
VENT DAMPER MUST BE LOCKED
IN THE FULL OPEN POSITION
TO OPERATE THE APPLIANCE
OPEN
Figure 36 - Opening Vent Damper
Hold-Down
Screw
Press
Spring Clip
to Release
Pivot Pin
Pivot Plate
CLOSE
17