Copying From A Video Cassette Recorder - Panasonic Diga DMR-EX99V Operating Instructions Manual

Copying from a video cassette recorder

e.g., Connecting to the AV3 input terminals on the front
≥Turn off the unit and other video equipment before connecting.
≥Connect to terminals of the same colour.
≥Refer to "Connecting a television and VCR, digital satellite receiver
or analogue decoder" when connecting to the AV2 input terminals
on the rear panel. ( 83)
This unit
IN 2 S VIDEO /MONO AUDIO R
VIDEO L
AV3 IN
S VIDEO VIDEO L/MONO - AUDIO- R
S Video
cable
§
Other video equipment
Connect to Audio/Video output terminals.
If the audio output of the other equipment is monaural
Connect to L/MONO on the AV3 input terminals at the front.
The S VIDEO terminal achieves a more vivid picture than the
§
VIDEO terminal.
About the aspect when recording a programme (
[HDD] [RAM] [-R] [-RW‹V›] [+R] [+RW] [VHS]
Preparation
≥Press [DRIVE SELECT] to select the HDD, DVD or VHS drive.
≥Press [REC MODE] to select the recording mode.
≥When recording bilingual programmes, select "M 1" or "M 2" on the
external equipment ( 26, Notes for recording).
≥When the output signal from the external equipment is NTSC,
change the "TV System" to "NTSC" in the Setup menu (
This unit cannot record NTSC signals to discs that already have
PAL signal recordings. (However, both types of programmes can
be recorded onto the HDD or VHS.)
≥To reduce noise in input from a video cassette recorder, set "Copy
NR" to "On" in the on-screen menu (
≥Check the time on the unit is correct.
Audio/Video
cable
26)
77).
68).
1
While stopped
Press [INPUT SELECT] to select the
input channel for the equipment you
have connected.
e.g., If you have connected to AV3 input terminals, select "AV3".
Recording to HDD or DVD
[HDD] [RAM] [-R] [-RW‹V›] [+R] [+RW]
Perform step 1 ( above).
2
Start play on the other equipment.
3
When you want to start recording
Press [¥ REC].
Recording starts.
Recording to VHS
[VHS]
Perform step 1 ( above).
2
Press [1] (PLAY).
Start playing the video cassette and find the recording start
point.
3
Press [;], then press [¥ REC].
Put the unit in recording standby mode.
4
Start play on the external device.
5
Press [;] at the point where you want
to start recording.
To skip unwanted parts
Press [;] to pause recording. (Press again to restart recording.)
To stop recording
Press [∫].
Almost all videos and DVD-Video on sale have been treated to
prevent illegal copying. Any software that has been so treated
cannot be recorded using this unit.
[HDD] [RAM] [-R] [-RW‹V›] [+R] [+RW]
≥Using Flexible Recording ( 29), you can record the content of a
video cassette (approx. 1–8 hours) to a 4.7 GB disc with the best
possible quality of recording without wasting disc space.
Note
≥If it becomes time for a timer recording to start while copying, the
recording will start and the copying will stop.
≥If video is copied from another piece of equipment to this unit, then
the video quality will be degraded.
≥[VHS] It is not possible to record SECAM signal on a video cassette.
VQT2J46
31