Cleaning And Care; Housing - Miele DA 420 V Operating And Installation Instructions

Cleaning and care

,
Before any cleaning or
maintenance work is carried out,
disconnect the rangehood from the
mains supply. Ensure that
– the mains fuse is withdrawn, or
– the screw-out fuse is removed
(in countries where this is
applicable).
,
Exercise caution when changing
halogen lamps. They get very hot
during use, and remain hot for some
time after being switched off. Do not
touch the surface directly when
changing a lamp, as grease
particles from your fingers will
adhere to the surface and damage
it.
The halogen lamps can also be
damaged if water is used to clean
them.
Wait several minutes after switching
off before beginning cleaning.
A range of Miele branded cleaning and
conditioning agents are available to
order through your Miele Chartered
Agent, from Miele or via the internet at
www.miele-shop.com.
22

Housing

General notes
The surfaces and controls are
susceptible to scratches and
abrasion. Please observe the
following cleaning instructions.
^ All external surfaces and controls can
be cleaned using warm water with a
small amount of washing-up liquid
applied with a well wrung-out soft
sponge or cloth.
^ Wipe the surfaces dry using a soft
cloth.
Do not use too much water when
cleaning the controls. Water could
penetrate the electronics and cause
damage.
Do not use:
– cleaning agents containing soda,
acids, chlorides or solvents,
– abrasive cleaning agents, e.g.
powder cleaners or cream cleaners
and abrasive sponges, as well as pot
scourers or sponges which have
been used previously with abrasive
cleaning agents. These will damage
the surface material.