Wireless Local Area Networks; Scan And Connect To A Wi-Fi Network - Motorola MC67 User Manual

92 | Wireless
7 Touch New APN.
8 Touch each APN settings and enter the appropriate data obtained from the wireless service provider.
9 When finished, touch
10 Touch Save.
11 Touch the radio button next to the new APN name to start using it.
12 Touch
.

Wireless Local Area Networks

Wireless local area networks (WLANs) allow the MC67 to communicate wirelessly inside a building. Before using
the MC67 on a WLAN, the facility must be set up with the required hardware to run the WLAN (sometimes known as
infrastructure). The infrastructure and the MC67 must both be properly configured to enable this communication.
Refer to the documentation provided with the infrastructure (access points (APs), access ports, switches, Radius
servers, etc.) for instructions on how to set up the infrastructure.
Once the infrastructure is set up to enforce the chosen WLAN security scheme, use the Wireless & networks settings
configure the MC67 to match the security scheme.
The MC67 supports the following WLAN security options:
• Open
• Wireless Equivalent Privacy (WEP).
• Wi-Fi Protected Access (WPA)/WPA2 Personal (PSK).
• Extensible Authentication Protocol (EAP).
• Lightweight Extensible Authentication Protocol (LEAP).
• FAST - with Microsoft Challenge-Handshake Authentication Protocol version 2 (MSCHAPv2) and Generic
Token Card (GTC) authentication.
• Protected Extensible Authentication Protocol (PEAP) - with MSCHAPV2 and GTC authentication.
• Transport Layer Security (TLS)
• TTLS - with Password Authentication Protocol (PAP), MSCHAP and MSCHAPv2 authentication.
The Status bar displays icons that indicate Wi-Fi network availability and Wi-Fi status. See
more information.
Note: Turn off Wi-Fi when not using it, to extend the life of the battery.

Scan and Connect to a Wi-Fi Network

Procedure:
1 Touch
.
2
Touch .
Send Feedback | January 2014 | MN000115A01
.
Status Bar on page 38 for