Power Connection - Raymarine RS130 GPS Installation Instructions Manual

Description Part No
DeviceNet adaptor cable A06046
(Male)
DeviceNet adaptor cable E05026
(Female) to bare ends.
DeviceNet adaptor cable E52027
(Male) to bare ends.
Cables and connections

3.7 Power connection

Notes
Allows the connection of
The power for the GPS receiver is provided by the SeaTalk
NMEA 2000 devices to
• The SeaTalk
a SeaTalk ng system.
backbone, via a SeaTalk
Allows the connection of
connector, or inline terminator.
NMEA 2000 devices to
• The SeaTalk
a SeaTalk ng system.
This can be provided by:
Allows the connection of
– A battery.
NMEA 2000 devices to
a SeaTalk ng system.
– A Raymarine course computer, via a SeaTalk system or a
If your vessel has a 24 V supply a suitable voltage convertor is
required.
• The power source must be protected by a 5 A fuse or a circuit
breaker providing equivalent protection.
• SeaTalk
supplied to the GPS receiver via the spur cable.
• Refer to the SeaTalk
general SeaTalk
ng GPS receiver must be connected to a SeaTalk
ng 5–way connector block, T-piece
ng system requires only ONE 12 V power source.
SeaTalk ng system.
ng cables carry both data and power signals. The power is
ng reference manual for more information on
ng power requirements.
ng system.
ng
17