MSI MS-9125 User Manual page 83

MS-9125 SSI Mainboard
SCSI Device Configuration
SCSI Device ID
Sync Transfer Rate (MB/Sec) ........ 320 320 320 320 320 320 320 320
Packetized......................................... Yes Yes Yes Yes Yes Yes Yes Yes
QAS................................................... Yes Yes Yes Yes Yes Yes Yes Yes
Initiate Wide Negotiation .............. Yes Yes Yes Yes Yes Yes Yes Yes
Enable Disconnection ..................... Yes Yes Yes Yes Yes Yes Yes Yes
Send Start Unit Command ............. Yes Yes Yes Yes Yes Yes Yes Yes
BIOS Multiple LUN Support ......... No
Include in BIOS Scan ...................... Yes Yes Yes Yes Yes Yes Yes Yes
SCSI Device ID
Sync Transfer Rate (MB/Sec) ........ 320 320 320 320 320 320 320 320
Packetized......................................... Yes Yes Yes Yes Yes Yes Yes Yes
QAS................................................... Yes Yes Yes Yes Yes Yes Yes Yes
Initiate Wide Negotiation .............. Yes Yes Yes Yes Yes Yes Yes Yes
Enable Disconnection ..................... Yes Yes Yes Yes Yes Yes Yes Yes
Send Start Unit Command ............. Yes Yes Yes Yes Yes Yes Yes Yes
BIOS Multiple LUN Support ......... No
Include in BIOS Scan ...................... Yes Yes Yes Yes Yes Yes Yes Yes
Sync Transfer Rate (MB/Sec)
The field allows you to specify the maximum synchronous data transfer
rate depending on the type of each SCSI device. Select ASYN to enable
asynchronous negotiation for some older SCSI devices.
Packetized
When enabled, this option is supported by the device drivers. However,
this option is not supported by the BIOS.
QAS
When enabled, this option is supported by the device drivers. However,
this option is not supported by the BIOS.
Initiate Wide Negotiation
When set to Yes, the field allows wide SCSI hard drives to use 16-bit (2
bytes) transfers.
Enable Disconnection
This field tells the SCSI controller whether or not to allow the specified
4-6
#0 #1 #2 #3 #4 #5
No No No No No
#8 #9 #10 #11 #12 #13 #14 #15
No No No No No
#6 #7
No No
No No