Epson EB-G6900WU User Manual page 94

List of Functions
Submenu
A/V Settings A/V Output: (This item can be set only if Standby Mode is
set to Communication On) Set this to Always On when the
projector is in standby status and you want to output audio
and images to an external device.
Monitor Out: Select the image source output to an external
monitor when the projector is in standby status. When set
to Auto, analog RGB signals from the Computer port or the
BNC port are output depending on which source was
selected when the projector was turned off.
Audio Settings: Perform the following audio related
settings.
• Audio Output: Select the audio to be output when
projecting images from the Computer port, BNC port,
S-Video port or Video port. When set to Auto, audio is
output from the audio input port corresponding to each
image input port.
s "Connecting Equipment"
• DisplayPort Audio Output: Select the audio source when
projecting images from the DisplayPort. If you select
DisplayPort, audio for the image is output as it is. If you
select Audio3, audio is output from the Audio3 port.
• HDMI Audio Output: Select the audio source when
projecting images from the HDMI port. If you select
HDMI, audio for the image is output as it is. If you select
Audio3, audio is output from the Audio3 port.
Standby Mode If you set Communication On, you can perform the
following operations even if the projector is in standby
mode.
• Monitor and control the projector over a network.
• Output audio and images to an external device. (Only
when A/V Output is set to Always On.)
• Communication from the HDBaseT port is enabled. (Only
when Control Communications is set to On.)
Function
p.31
Submenu
HDBaseT Make settings when the optional HDBaseT Transmitter is
connected to the HDBaseT port.
Control Communications: When set to On, Ethernet
communication from the HDBaseT port, serial
communication, and control using the wired remote control
connected to the optional HDBaseT Transmitter are all
enabled. (When this is enabled, the projector's LAN port,
RS-232C port, and Remote port are disabled.)
Make settings when projecting from multiple projectors.
Multi-Projection
s "Multi-Projection Function"
Brightness Level: When the brightness of each lamp differs,
set the lamp brightness level between 1 and 5. This item can
be adjusted only when Power Consumption is set to
Normal from the Settings menu.
Edge Blending: Corrects a border between multiple images
to create a seamless screen.
s "Adjust the Edges of the Images (Edge Blending)"
p.59
Multi-screen: You can adjust the tint and brightness of each
projected image.
s "Adjusting to Match Colors"
Projector ID: Set the ID from 1 to 9. Off indicates that no
ID is set.
s "ID Settings"
Schedule Set- You can set the projector's schedule so that it performs a
tings specific operation at a pre-scheduled time.
s "Scheduling Function"
You can set the language for messages and menus.
Language
Function
p.57
p.63
p.28
p.75
94