Table of Contents
Advertisement
List of Functions
Submenu
Sync.
(Only available when an analog RGB computer signal is being
input.)
You can adjust computer images when flickering, fuzziness, or
interference appear in the images.
Position
You can adjust the display position up, down, left, and right when
a part of the image is missing so that the whole image is projected.
When projecting passive 3D images using two projectors, set 3D
3D Setup
Images to On.
g
Interlace
Progressive
conversion)
Off: Ideal for images with a large amount of movement.
Video: Ideal for general video images.
Film/Auto: This is ideal for movie films, computer graphics, and
animation.
You can play fast moving images smoothly by producing
Frame Interpola-
intermediate frames between the original frames.
tion (EB-
G6900WU only)
Noise Reduction
(This cannot be set when Image Processing is set to Fast.)
Smoothes out the roughness in progressive images. There are
two modes. Select your favorite setting. It is recommended that
this is set to Off when viewing image sources in which noise is
very low, such as for DVDs.
Mosquito NR
(This cannot be set when Image Processing is set to Fast.)
When a progressive signal is being input, you can reduce the
wavy noise that occurs in lines between areas with dramatic
changes in colors.
Video Range
Select the video range for the input signal from the HDMI port,
the DisplayPort, HDBaseT port, or the SDI port (EB-G6900WU
only). Set to Expanded if you are concerned about misadjusted
black levels or blown out highlights in the image.
Function
g
(i) signal is converted to Progressive
Submenu
Input Signal
Video Signal
(p). (IP
Aspect
Scale
Overscan
Image Process-
ing
DisplayPort EQ
Setting
Function
You can select an input signal from the Computer port or BNC
port.
If set to Auto, the input signal is set automatically according to
the connected equipment.
If colors do not appear correctly when set to Auto, select the
appropriate signal according to the connected equipment.
You can select an input signal from the Video port or S-Video
port. If set to Auto, video signals are recognized automatically. If
interference appears in the image or a problem occurs such as no
image is being projected when set to Auto, select the appropriate
signal according to the connected equipment.
g
You can set the aspect ratio
for projected images.
s "Changing the Aspect Ratio of the Projected Image "
When using multiple projectors to project one image, adjust the
range of the image displayed by each projector.
s "Scaling an Image (Scale)"
p.64
(This setting can only be adjusted when a component video
signal is being input.)
Changes the output image ratio (the range of the projected
image). You can set the cropping range to 4% or 8%. When set to
Auto, this is automatically adjusted according to the input signal.
Changes settings for image processing.
Fast: Images are displayed quicker.
Fine: Images are displayed in higher quality.
Adjusts the DisplayPort input signal level depending on the
devices connected to the DisplayPort. If there is a lot of
interference in the image, or if a problem such as no image being
projected occurs, select 1 or 2, and then confirm the selection.
89
p.50
Advertisement
Table of Contents
