Table of Contents
Advertisement
Adjusting Projected Images
a
Each time you press the [
image and the grid.
h
Use the [
], [
], [ ], and [ ] buttons to select the area you
want to adjust, and then press the [
Adjustment tips
When selecting Horizontal Corner:
Adjust the upper area based on the lowest point (indicated by a blue
arrow).
Adjust the lower area based on the highest point (indicated by a red
arrow).
] button, you can show or hide the
] button.
When selecting Vertical Corner:
Adjust the left and right based on the point nearest to the vertical
line in the center of the screen.
a
If the [Esc] button is pressed for at least 2 seconds, the confirm
default reset screen is displayed.
Select Yes to reset the result of Corner Wall.
i
Use the [
][
][ ][ ] buttons to adjust the shape.
If the message "Cannot adjust any further." is displayed while
adjusting, you cannot adjust the shape any further in the direction
indicated by the gray triangle.
j
Repeat procedures 8 and 9 as needed to adjust any remaining
parts.
If the image expands and contracts, go to the next step and adjust
the linearity.
k
Press the [Esc] button to return to the screen in step 4. Select
Linearity, and then press the [
48
] button.
Advertisement
Table of Contents
