Safety Instructions For Installation - Miele CS 1411 Operating And Installation Instructions

Deep fat fryer
Table of Contents

Advertisement

Safety instructions for installation

Fit the wall units and extractor hood
before fitting the appliance to avoid
damaging the surface.
~
An electric fryer must not be
installed directly next to a gas hob, as
the gas flames could ignite the oil in the
fryer. It is essential to maintain a
distance of at least 288 mm between
these two appliances.
~
The veneer or laminate coatings of
worktops (or adjacent kitchen units)
must be treated with 100 °C
heat-resistant adhesive which will not
dissolve or distort.
Any backmoulds must be of
heat-resistant material.
~
This equipment may only be used in
mobile installations such as caravans,
aircraft etc. if a risk assessment of the
installation has been carried out by a
suitably qualified engineer.
~
After installing the appliance, ensure
that the connection cable is without
hindrance and that there is no
mechanical obstruction which could
damage it, e.g. when draining the
appliance.
24
~
Do not use any sealant except
where expressly instructed to do so.
The seal underneath the appliance
provides a sufficient seal for the
worktop (see "General installation tips").
~
Observe carefully the safety
distances given on the following pages.
All dimensions in this instruction booklet
are given in mm.

Advertisement

Table of Contents
loading

Table of Contents