Safety instructions for installation
To avoid the risk of damaging the
appliance fit the wall units and
extractor hood before installing it.
~
An electric fryer must not be
installed directly next to a gas hob, as
the gas flames could ignite the oil in the
fryer. It is essential to maintain a
distance of at least 288 mm between
these two appliances.
~
The veneer or laminate coatings of
worktops (or adjacent kitchen units)
must be treated with 100 °C
heat-resistant adhesive which will not
dissolve or distort.
Any backmoulds must be of
heat-resistant material.
~
This appliance must not be used in
non-stationary location, (e.g. on a ship).
~
After installing the appliance, ensure
that the connection cable is without
hindrance and that there is no
mechanical obstruction which could
damage it, e.g. when draining the
appliance.
~
To prevent the risk of heat damage
to the electrical cable, please ensure
that it is installed in such a way that it
cannot touch any parts of the appliance
which become hot.
28
~
Do not use any sealant except
where expressly instructed to do so.
The seal underneath the appliance
provides a sufficient seal for the
worktop (See "General installation tips").
~
Observe carefully the safety
distances given on the following pages.
All dimensions in this instruction booklet
are given in mm.