JVC LM-15G Instructions Manual page 12

SYSTEM SETTING menu
SYSTEM SETTING
Exit
SIGNAL LEVEL
DISPLAY
OSD POSITION
COLOR SYSTEM
AGC
REMOTE
All reset
SIGNAL LEVEL: You can choose the signal level from "STD." or "AMP.".
STD.: Select this for normal operation.
AMP.: Select this to watch dark part of the picture better.
DISPLAY: If you select 'DISPLAY' and press the 'MENU/ENTER' button, you can confirm the current status;
resolution, Horizontal frequency and Vertical frequency.
COLOR SYSTEM: You can choose the color system from NTSC, PAL, BW60 or BW50. Choose the correct color
system when the color is abnormal or no color appears.
AGC: You can turn the AGC (Auto Gain Control) function on (ON) or off (OFF).If you select off(OFF), you can adjust
contrast bar.
REMOTE: If you select ON, you can only do remote control. If you select OFF, you can control only by using the
monitor's buttons.
Exit: If you select "Exit" and press the 'MENU/ENTER' button, the menu will disappear.
All reset: If you select "All reset" and press the 'MENU/ENTER' button, the settings will be return to the factory
settings.
* "COLOR SYSTEM" and the input select will not be return to the factory settings.
OSD POSITION:
You can adjust the position of the menu on the screen as following procedure.
1. Select "OSD POSITION" and press the 'MENU/ENTER' button, the sub-menu will appear.
OSD POSITION
Next page
H. POSITION
V. POSITION
2. Press 'UP' and 'DOWN' button to choose "H. POSITION" (horizontal position) or "V. POSITION" (vertical
position), and then press 'MENU/ENTER' button to display the adjusting menu
3. Press 'UP' and 'DOWN' button to adjust the position of the menu on the screen.
4. Press 'MENU/ENTER' button to return to the "OSD POSITION" menu.
Next page: If you select 'Next
CONTRAST menu
You can adjust the contrast of the image from the PC.
－
page' and press the 'MENU/ENTER' button, the next menu will appear.
CONTRAST
11
50
＋