Connecting Network With Wps Setting - Samsung Smart A/C application User Manual

Connecting network with WPS setting

1-2
1-1
1. After pressing the [2
nd
message will be displayed on the front display panel of the air conditioner.
2. Press [WPS] button on the wireless router that will be connected to an air conditioner and operate the WPS function of
the wireless router. (The location of WPS button may be different depending on the wireless manufacturing company.)
3. After connecting the air conditioner with the wireless router correctly, the Wi-Fi (
on.
• Check whether the wireless router supports Wi-Fi Protected Setup™(WPS).
• Check whether the wireless router has WPS button.
NOTE
• Samsung smart air conditioner uses PBC method of WPS.
• When searching a network by pressing [WPS] button, the remote controller will not work for a maximum of 2
minutes.
• Be careful when pressing the WPS button because if you hold the WPS button for a long time, the set value of the
wireless router will be initialized with some types of wireless router.
• Operating wireless router through WPS mode might be different depending on the manufacturing company.
Therefore, please refer to the user manual of your wireless router.
• If the wireless router(AP) is not authenticated with WPS, connection failure might occur.
• Some of the wireless routers (including wireless routers that are not authenticated with WPS) may lose connection
CAUTION
with previously connected devices when the air conditioner establishes connection with wireless router.
A3050 ET WiFi APP_IB_04209A-00_EN.indd 11
F] button on the remote controller, press the [WPS] button.
English-11
2
) light on the Wi-Fi module will be
2013-10-11 14:49:37