Trusted Platform Module (Optional) - Fujitsu LIFEBOOK S Series Easy Manual

Security functions
Switching on the PC with SystemLock
If you switch on the notebook with an On/Off switch then the following message appears:
Insert a SmartCard
► Insert your SmartCard.
The following message appears: Enter PIN:
► Enter your PIN.
If you have entered the PIN correctly, the operating system is booted.
If you have entered the PIN incorrectly once or twice, then the following message appears:
Invalid PIN/PUK
If you have entered the PIN incorrectly three times, the SmartCard is blocked and the following
message appears:
The SmartCard is blocked
The SmartCard can only be enabled again by entering the PUK.
Deactivating SmartCard as system protection (SystemLock) again
If you no longer want to use this security function of your notebook, you must deactivate the
SmartCard SystemLock function in the BIOS Setup. This can only be done with the Supervisor
SmartCard.
► Call BIOS Setup and select the Security menu.
► Mark the SmartCard Security field and press the Enter key.
► Mark the SmartCard SystemLock field and press the Enter key.
► Select the Disnabled field and press the Enter key.

Trusted Platform Module (optional)

To use the TPM, you must be sure to activate the TPM in the BIOS Setup before the software
installation. The condition for this is that you have assigned at least the supervisor password (see
the "Set the supervisor and user password" section).
You can start the BIOS Setup by pressing the F2 key while booting the system.
Activate the TPM by selecting the entry Enabled for Embedded Security Chip in the Security menu. If you
have activated the TPM, the menu item Clear Security Chip appears.
You can use this menu item to delete the holder in the TPM. However, you can then no
!
longer access the data you have encrypted on the holder-based keys.
66 A26391-K164-Z120-1-7619, edition 2