Fujitsu LIFEBOOK S Series Easy Manual page 75

Initialise the Supervisor SmartCard and the User SmartCard and activate the SmartCard
Security (SystemLock)
► Call BIOS Setup and select the Security menu.
► Mark the SmartCard Security field and press the Enter key.
► Mark the SmartCard SystemLock field and press the Enter key.
► Select the Enabled field and press the Enter key.
► Now insert your SmartCard and select Yes in the Setup Confirmation window.
► Enter your PUK in the Enter PUK field and press the Enter key.
The following message appears: Supervisor SmartCard initialized
After you have successfully initialised your Supervisor SmartCard, you must initialise the User
SmartCard:
► Mark the Initialize User SmartCard field and press the Enter key.
► Now insert your User SmartCard, enter your PUK in the Enter PUK window and press the Enter
key.
The following message appears: User SmartCard initialized
Your Supervisor and User SmartCard are now ready to use. However, for security reasons
i
we urgently recommend that you change your PIN and your PUK.
Changing PIN and PUK
► Call BIOS Setup and select the Security menu.
► Mark the SmartCard Security field and press the Enter key.
► Mark the Change PIN field and press the Enter key.
► Insert the SmartCard for which you want to change the PIN and press the Enter key.
► In the Change PIN window, first enter your old PIN, assign your new PIN in the next line and
confirm it again in the Confirm New Pin window.
The following message appears: PIN has been changed
To change your PUK, you must select the Change PUK field and carry out the same steps.
For the new PIN and new PUK , 4 to 8-digit numbers are acceptable.
i
For security reasons, we recommend that you change the PIN and PUK for every
SmartCard, and use an 8-digit number each time.
A26391-K164-Z120-1-7619, edition 2
Security functions
65