Fujitsu LIFEBOOK S Series Easy Manual page 55

4
► Make sure that the hoop (a) is in the position illustrated.
► Position the notebook (1) so that the rear left-hand corner lies on the Port Replicator, as shown
in the illustration (b).
► Press down on the notebook's rear corners so that it may lock into position.
► Connect the power adapter cable to the DC jack (DC IN) of the Port Replicator (2).
► Connect the power cable to the power adapter (3).
► Plug the power cable into the mains socket (4).
If the notebook is connected to a Port Replicator, the operating system creates an
i
hardware profile for the "Docked" mode. In this profile, for example, the setting is saved as
to which monitor was last used for output. This profile will be loaded, as soon as the
notebook is connected to any desired Port Replicator.
A26391-K164-Z120-1-7619, edition 2
2
3
b
Using your notebook
1
a
45