Assigning The User Password - Fujitsu LIFEBOOK S Series Easy Manual

► Enter the programme name FJSECS.EXE under Start - Run.
► Click on OK.
The programme starts.
The program instructions will help you configure the password.
With a combination you must press the security keys with these numbers simultaneously
i
later when entering the password.

Assigning the user password

The setup programme can be found under Start - AddOn.
► Double-click on the symbol to start the setup programme for FJSECU.EXE.
The programme starts.
or
► Enter the programme name FJSECU.EXE under Start - Run.
► Click on OK.
The programme starts.
The program instructions will help you configure the password. Enter the user password with its
numbers and number combinations in the same way as the supervisor password.
A26391-K164-Z120-1-7619, edition 2
You see a field with five lines and 4 keys each
with the numbers 1 to 4 for selecting your
password. You can select one number or a
combination of several numbers in each line.
► Click one to four keys in the first line.
► You can also click a key or key combination
in additional lines if desired.
Here it is important that you do not skip a
line. In the end your password consists of
one to five numbers or one to five number
combinations.
An example:
Here the combination 2, 3 was selected in the
first line, the number 4 in the second line, the
combination 1, 3 and 4 in the third line, the
number 2 in the fourth line and finally the
combination 1, 2, 3 and 4 in the fifth line.
In this case the supervisor password is then:
2/3 4 1/3/4 2 1/2/3/4
Security functions
55