Serial Connections And Operations; Connecting The Remote Control Cables; Assigning Id Numbers - JVC GD-V4200PCE Instructions Manual

Serial Connections and Operations

When the Monitors are serially connected, you can control all of them at the same time (simultaneous operation) or control them
one by one separately (individual operation).
For individual operation, you have to assign an ID number to each of the Monitors.
For the purpose of explanation, we will call Monitor 1 as a Master and Monitor 2 and subsequent Monitors as Slaves.

Connecting the Remote Control Cables

Remote control
Notes:
• Do not connect the last monitor to Monitor 1.
• When operating with a wired remote control, connect it to the REMOTE CONTROL input terminal of Monitor 1.
• When Monitors are serially connected, Monitor 2 and subsequent Monitors cannot be directly controlled with a wireless
remote control.
• Even after the Monitors are serially connected, each of them can be operated using the buttons on the Monitor. However,
you cannot perform simultaneous or individual operation even with the buttons on Master Monitor.

Assigning ID Numbers

• When performing simultaneous or individual operation,
use the remote control.
DISPLAY
VIDEO A
MUTING
MULTIPLE
MODE
MODE
ID SET
MENU/EXIT
MENU/EXIT
RM-C575 REMOTE CONTROL UNIT
24
Monitor 1
(Master)
RS232C CONTROL
IN
WIRED
(MULTIPLE MONITOR ADJUSTMENT)
Remote control
OUT
REMOTE CONTROL
cable (supplied)
Remote control cable
(supplied with
Monitor 1)
ASPECT POWER
VIDEO B COMPO.
RGB
VOLUME
MONITOR ADJUSTMENT
ID
ID SET
ID +/–
2 / 3
5 /
Monitor 2
Monitor 3
(Slave)
(Slave)
AC INPUT I MAIN POWER RS232C CONTROL AC INPUT I MAIN POWER
(100V) (100V)
IN IN
SPEAKER OUT SPEAKER OUT
WIRED
(MULTIPLE MONITOR ADJUSTMENT)
OUT OUT
REMOTE CONTROL
INTERNAL EXTERNAL INTERNAL EXTERNAL
Remote control cable
Remote control cable
(supplied with
(supplied with
Monitor 2)
Monitor 3)
The following procedure should be performed slowly and
securely.
1
Turn on all the connected Monitors.
2
Press MODE.
Master
MASTER
On Master Monitor screen, "MASTER" is displayed, and
"[00]" is displayed on all of Slave Monitor screens.
3
Press ID SET.
Master
MASTER
On the Slave Monitor screens, "[01]", "[02]", "[03]", ——
5
and so on will be displayed in the order of connection.
Notes:
• When a maximum number of 20 Monitors are connected, it
will take approx. 10 seconds for ID numbers to be displayed
on all the screens.
• If "[00]" is displayed on all the Monitor screens or if some
of the Monitors have no indication in step 1, press MODE to
turn off the indications on all Monitor screens, and then
press MODE again.
Monitor XX
(Slave)
RS232C CONTROL AC INPUT I MAIN POWER RS232C CONTROL
(100V)
IN
SPEAKER OUT
WIRED WIRED
(MULTIPLE MONITOR ADJUSTMENT) (MULTIPLE MONITOR ADJUSTMENT)
OUT
REMOTE CONTROL REMOTE CONTROL
INTERNAL EXTERNAL
Slave 1
Slave 2
[00] [00]
Slave 1 Slave 2
[01] [02]
AC INPUT I M
(100V)
SP
INTER
Slave XX
[00]
Slave XX
[XX]