Remove Your Existing; Rinse Spray And Hose; Straighten The Dispenser Tubes - InSinkErator Steamin' Hot H-770 Installation, Care And Use

OK... Let's
get on with
the
installation

RINSE SPRAY AND HOSE

C
Now pull the spray head and hose entirely out
Of the hole. Then plug the faucet tube opening
With either a 1/8" plug or 1/4" cap (not supplied).
NOW, WE INSTALL THE DISPENSER HEAD
3
A
Place the dispenser head with #10-24 mount-
ing screw and gasket attached down through
the mounting hole. Then while an assistant holds
the dispenser head in place, secure the head as
shown in steps B and C.
FIRST, LET'S REMOVE YOUR EXISTING
1
A
If you have a spray unit like this one on your
kitchen sink, the hole is perfect for mounting
your Hot Water Dispenser's head.
D
Next, remove the nut from the bottom of the
washer flange in the spray hole. If you don't
Have enough room for an ordinary wrench, you
May need a basin wrench.

STRAIGHTEN THE DISPENSER TUBES

2
The tubes to the dispenser head are curved for easier packing and
shipping. To straighten, hold the head down with one hand while working
the lubes down slowly with your other hand. See Caution, step 8.
B
Working from below sink, place semi-circular
metal mounting washer over the mounting
screw.
B
A nut connects the spray hose to a tube at the
bottom of your faucet. FIRST, BE SURE
FAUCET IS TURNED OFF. Then remove this nut.
What if you don't use a
sprayer hole?
You can cut a mounting hole
through a stainless steel sink with
a 1-1/4" (32mm) chassis punch.
Rent or purchase one at your
hardware or electrical supply store.
Or, mount the Hot Water
Dispenser's head in a 1-1/4"
(32mm) hole drilled through your
countertop with an expandable
wood bit. Don't attempt to drill a
hole through a cast iron or porce-
lain covered sink unless you have
the proper tools and skills.
C
Now, simply tighten the screw and your dis-
penser head will be secured to the sink.